Serial CAN Bus Module with MCP2551 and MCP2515

The Serial CAN BUS Module provides your Arduino or other microcontroller board with the capability to communicate with CAN bus. This module is based on MCP2551 and MCP2515, with a CAN Bus speed of up to 1Mb/s. With simple AT commands you can set serial baud rate, CAN bus baud rate, mask and filter.

• UART to CAN bus communication
• Works with Arduino, BeagleBone, Raspberry Pi or any MCU that has an UART
• AT commands
• Up to 115200 UART baud rate (default 9600)
• Up to 1Mb/s CAN bus baud rate
• TX and RX led indicator
• 4pin Grove connector
• 5V working voltage
• Easy-to-use Arduino library
• Small size: 20x40 mm

More information on the websites of Seeed Studio, Longan Labs and Hackster.