The HUZZAH32 is the ESP32-based Feather, made with the official WROOM32 module. It has built in USB-to-Serial converter, automatic bootloader reset, Lithium Ion/Polymer charger, and just about all of the GPIOs brought out. That module nestled in at the end of this Feather contains a dual-core ESP32 chip, 4 MB of SPI Flash, tuned antenna, and all the passives you need to take advantage of this powerful new processor.
The ESP32 has both WiFi and Bluetooth Classic/LE support. It comes fully assembled and tested, with a USB interface that lets you quickly use it with the Arduino IDE or the low-level ESP32 IDF.
More information is available on the website of Adafruit.
Bundles
-
X1HUZZAH32 – ESP32 Feather Board+X1Breadboard - Self-Adhesive (White)Breadboard - Self-Adhesive (White)
This self-adhesive breadboard has 400 tie in points.
Specifications on the website of Sparkfun.+X17" Jumper wires, 30 pieces7" Jumper wires, 30 pieces
These 7" (18 cm) long wires are suitable for a breadboard. They come in a set of 30 pieces in different colors.
Incl. BTW:€36.79 €29.12
Excl. BTW:€36.79 €30.46
50.04% discount on accessories
Experimenter basic -
X1HUZZAH32 – ESP32 Feather Board+X17" Jumper wires, 30 pieces7" Jumper wires, 30 pieces
These 7" (18 cm) long wires are suitable for a breadboard. They come in a set of 30 pieces in different colors.
+X1Breadboard - Self-Adhesive (White)Breadboard - Self-Adhesive (White)
This self-adhesive breadboard has 400 tie in points.
Specifications on the website of Sparkfun.+X1Resistor Kit - 1/4W (500 total)Resistor Kit - 1/4W (500 total)
The resistor kit comes with 25 each of 20 different resistor values. All of these resistors are stapled into a tri-fold pack and clearly labeled. The back of the resistor kit even has a resistor color code look-up chart and a table of color codes for the included resistors.
The contents of the kit is described on the website of Sparkfun.
+X1USB A - B CableIncl. BTW:€51.61 €38.31
Excl. BTW:€51.61 €40.62
40.01% discount on accessories
Experimenter plus